To label these iterations you simply need to connect a panel, a number slider, and concatenate component. This is powerful because you can control where these calculations are saved. It is useful to turn the component off until you are ready to test results, as every manipulation will require grasshopper to recalculate the thermal analysis! This will allow you to turn the component on or off. To run the thermal analysis, connect a Boolean toggle component to the run input. Connect the construction assemblies that define the space into the zone input on the viper component. Thermal analysis in grasshopper is done using the viper component. If you have multiple surfaces that have the same construction, simply click select multiple surfaces.įor reference watch this video by Jeff Niemasz Right click on the construction assembly to set the construction type and appropriate R value.Īssign and label all the surfaces that make the zone you would like to analyze. Again, open the grasshopper command line and type “construction assembly.” Connect the surface to the construction assembly by dragging the output of the surface component to the input of the construction assembly component.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |